You can use the Hardware Utility to scan for Light-O-Rama Directors.
Before Scanning
Before scanning for Directors, check that:
•Only 1 Director is attached to the USB adapter, and the cable from the adapter is plugged into Network 1 of the Director.
•There is no SD card in the slot
•The Director has power:
oIf you are using a Light-O-Rama USB485B (adapter with booster), it will supply power to the Director.
oIf there is also a LOR controller with accessory power in the daisy chain, then it can supply power.
oOtherwise, connect an external 12V DC power supply to the unit's barrel jack.
Scan result for a Director
Ready To Scan
Now that the Director is connected properly:
1.Select the port that the Director is attached to. Set Scan For to "Directors"
2.Click the "Scan" button
3.Wait for results to appear at the bottom of the page
4.Click the "Configure" button next to the device you want to configure. This will open the page shown below.
2 and 4 port Directors have a clock and you can set their time from your computer
If you have a 2 or 4 port Director, you will be able to set the device's time from the "Configure" page. Clicking the "Set director to current time" button will send your computer's time to the Director. The display on the Director should immediately reflect the updated time.